Turbocharger Spare Parts: What Gets Replaced in an Overhaul?

The marine turbocharger spare parts renewed most often: bearings, seals, nozzle ring, compressor wheel and turbine rotor, and the wear signs to look for.

2 min read
  • Spare Parts
  • Turbocharger
  • Dynamic Balancing
Turbocharger compressor wheel and rotor shaft

Why do turbocharger parts wear?

A turbocharger rotor turns at tens of thousands of revolutions per minute; the turbine side runs in hot exhaust gas and the compressor side in intake air. Speed, heat, soot and oil quality are the main factors behind wear.

In an overhaul the turbocharger is dismantled and its parts are cleaned, measured and compared with the maker's limits. Parts outside the limits are renewed and those within them are reused. These measurements produce the list of turbocharger spare parts to replace.

The turbocharger spare parts renewed most often

These are the parts most often renewed in overhauls:

  • Bearings and bushes: the first to wear, with lubrication problems and running hours
  • Seals and labyrinths: when worn, they cause oil leaks and a loss of efficiency
  • Nozzle ring: hot gas erodes the vanes until they thin or crack
  • Compressor wheel: foreign object impact or erosion damages the blade tips
  • Turbine rotor and shaft: blade damage and wear on the bearing journals
  • Gasket and fitting sets: renewing them at every dismantling is recommended

Signs of wear

Worn parts usually show up in the operating readings:

  • Higher exhaust temperatures and lower charge air pressure at the same load
  • Rising vibration or a change in the rotor's sound
  • Oil traces on the compressor or turbine casing
  • The rotor rubbing when turned by hand, or increased axial play

Balancing after parts are renewed

When a part on the rotor is renewed or the blades are cleaned, the rotor's balance can change. An unbalanced rotor loads the bearings heavily at high speed and soon ruins the new parts. So after parts are renewed, dynamic balance should be checked and clearances measured and recorded.

When requesting turbocharger spare parts

The model and serial number on the turbocharger name plate matter most. Photos of the plate and the damaged part, the running hours since the last overhaul and the symptoms seen all speed up preparing the right parts list.

Frequently asked questions

Are the bearings always renewed in a turbocharger overhaul?

Most makers recommend renewing bearings at set running hours. Measurement results and the maker's instructions are weighed together.

Can a damaged compressor wheel be repaired?

It depends on the type and extent of damage. Light erosion at the blade tips can sometimes be dressed out; a cracked or broken blade means a new wheel.